Jim Dunlop MXR M116 Fullbore Metal Guitar Effect

M116
The Fullbore Metal Distortion provides high-gain distortion a 3-band EQ, a midrange sweep control, a Scoop switch, and a switchable Noise Gate with internal sensitivity control.
This pedal can be powered by a 9-volt battery, a Dunlop ECB003 9-volt adapter, or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies (not included).
• Super high-gain distortion
• 3-band EQ with midrange sweep
• SCOOP switch boosts highs and lows
• Switchable Noise Gate with sensitivity control

CONTROLS
1. VOLUME knob controls overall effect volume
2. FREQ knob selects the midrange frequency (200Hz to 5KHz) that is adjusted by the MID control
3. GAIN knob controls the overall amount of distortion
4. GATE button activates the noise gate
5. SCOOP button boosts highs and lows (EQ still functional)
6. LOW knob controls the amount of low end
7. MID knob controls the amount of midrange selected by the FREQ control
8. HIGH knob controls the amount of high end
9. FOOTSWITCH toggles effect on/bypass (blue LED indicates on)

DIRECTIONS
• Run a cable from your guitar to the Fullbore Metal’s INPUT jack and run another cable from the Fullbore Metal’s OUTPUT jack to your amplifier.
• NOTE: Start with Volume, Gain, and Bass at their lowest setting (fully counterclockwise). This pedal is very dynamic and adds tons of gain—be warned!
• Turn the effect on by depressing the footswitch.
• Adjust the Gain, Volume, Low, Mid, Freq and High controls until the desired output and tone is acquired.
• Depress the SCOOP button (red LED lit) for a scooped nu-metal sound that accentuates the low and high frequencies.
• To sharpen the attack of syncopated rhythms or to cut down on excess noise, depress the GATE button (green LED lit). To adjust the GATE control’s sensitivity, please refer to diagram A

SPECIFICATIONS
• Input Impedance >450 kΩ
• Output Impedance <10 kΩ
• Noise Floor*
• Gate OFF -70 dBV
• Gate ON -85 dBV
• Frequency Response
• Gate OPEN 0 dB, 20 Hz to 20 kHz
• Gate CLOSED -20 dB at 500 Hz
• -25 dB at 20 kHz
• Tone Controls
• Low ±9 dB at 100 Hz
• Mid ±16 dB at 200 Hz to 5 kHz
• High ±12 dB shelf at 1.5 kHz
• Bypass True Hardwire
• Current Draw 18 mA
• Power Requirement 9 volts DC