Bose PowerShare PS404D Adaptable Power Amplifier

Features
• PowerShare Technology – Patented PowerShare technology allows the total 400 watts of power to be shared asymmetrically across all outputs, as each output is capable of delivering full power. Instead of selecting amplifier power based on the needs of the largest zone, installers now have the freedom to use total amplifier power in the application. This enables more flexibility during the initial design, or later on-site when making unplanned changes that take advantage of surplus power.
• Load-Independent Outputs – Each channel can be configured for low-impedance (4-8 Ω) or high-impedance (70/100V) applications without bridging, use of jumpers, or software settings.
• DFL™ System – The Dual Feedback Loop system, inherited from the field-proven Bose PowerMatch® amplifier line, improves performance and reliability through continuous monitoring and control of both the current and voltage delivered to each output load. This combination provides improved linearity and lower distortion, while protecting loudspeakers.
• Integrated Loudspeaker Processing with Optional PowerShare Editor Configuration – For applications requiring additional signal processing the PowerShare Editor Software offers real-time selection and control of Bose loudspeaker EQs, 9-band PEQs, matrix mixing, crossover, delay, and mute/output polarity through a USB connection. For basic setups without a PC, rear-panel settings allow installers to recall Bose loudspeaker equalization and protection per output channel. These features eliminate the need for an external signal processor in many applications.
• AmpLink – Transports up to 24 uncompressed, near zero latency, digital audio channels between Bose DSPs and the PowerShare PS404A via shielded CAT 5 cable. The amp also supports a THRU path for daisychaining up to 8 other Bose AmpLink amplifiers, at a distance of up to 10 m between products. Any combination of AmpLink amplifiers can be daisychained.
• ControlCenter Zone Controller Accessories – Bose ControlCenter CC-1 zone controllers can be directly attached for remote adjustment of amplifier outputs, further extending stand-alone amplifier applications.
• Auto-Standby – Designed to save power consumption when not in use. PowerShare amplifiers can be configured to automatically enter standby mode when the audio signal falls below a set threshold, then wake when audio returns.
Technical Data
• Amplifier Power: 4 x 100 Watt nominal
• Max. Power per channel: 400 Watt
• Impedances: 4-8 Ohm / 70/100 Volt
• Frequency range: (at 1W +/- 0.5 dB) 20 Hz – 20 kHz
• Signal to noise ratio: >99 dB(A)
• Distortion factor: (THD 1W, 20Hz-20 kHz) <0.4
• Channel separation: at 1 kHz >65 dB
• Inputs: 4x balanced line level on Phoenix terminal; AmpLink digital input
• Outputs: 4-fold Phoenix terminal
• A/D and D/A conversion in DSP 24 bit/48 kHz (per channel)
• Latency time (Analog in – amplifier output): 1 msec
• Signal matrix 4×4 with level setting for each crossing point